To the Editor:-There are many devices used to deliver topical anesthetics to the airway. Some devices consist of spraying or nebulizing local anesthetics by means of high-flow oxygen. [1,2] We use a variation of controlled aerosolization of lidocaine by assembling materials that are readily available in the operating room (Figure 1). This device consists of an oxygen tubing fitted to the female end of a three-way stopcock with a 20- or 22-gauge intravenous plastic catheter attached to its male end. The oxygen tubing is connected to an oxygen source set at 2–6-l/min flow rate. A syringe filled with lidocaine solution of desired volume and concentration is attached to the other female end with a one-way valve (e.g., made by Arrow-Walrus) in between to prevent back-flow of pressurized oxygen toward the syringe. When lidocaine is slowly injected to the system, it is broken into a forceful spray by the high flow of oxygen. It is lightweight, disposable, and cost-effective and does not involve complicated apparatus. It can be used to anesthetize the nasal passage, palate, tongue, pharynx, and larynx with little discomfort on the part of the patient.

Joselito T. Balatbat, M.D.

CA2 Chief Resident

John E. Stocking, M.D.

Associate Professor (Clinical Service) and Chief of Anesthesia; Louisville VAMC

Benjamin M. Rigor, M.D.

Professor and Chairman; Department of Anesthesiology; University of Louisville Hospital; Louisville, Kentucky 40202–3617;jestoc01@athena.louisville.edu

(Accepted for publication April 2, 1999.)

REFERENCES 

1.
Benumof JL: Airway Management, Principles and Practice. St. Louis, Mosby-Year Book, 1996, pp 1168-9
2.
Garewal DS, Sharma A, Smith T: Jetting lidocaine through the atomizer (letter). Anesthesiology 1999; 90:634